LANG DENTAL | COLD CURE DENTURE BASE
05 | Quality Control: From Mix to Finished Base A professional laboratory workflow treats quality control as a sequence of checks, not a final visual inspection alone. Each stage can influence the consistency of the finished appliance.
Before processing • Verify the product name, lot information, expiry date and packaging condition. • Read the current instructions for use and SDS; confirm the intended application. • Prepare clean tools, suitable ventilation and the specified protective equipment. • Check the prescribed powder-liquid ratio and required equipment.
During processing • Measure accurately; do not estimate ratios by eye. • Follow the specified mixing sequence and working time. • Avoid introducing contaminants or unnecessary air during handling. • Use only the manufacturer-approved curing conditions and equipment.
After curing • Allow the material to complete the prescribed cycle before deflasking or finishing. • Inspect for visible porosity, cracks, incomplete adaptation, roughness or other defects. • Trim and polish using appropriate laboratory procedures without compromising the base. • Document any process deviation and follow the lab’s quality procedures.
A note on fit and finish A smooth, attractive surface is important, but appearance alone cannot confirm that a denture base meets all functional or material requirements. Fit, adaptation, processing integrity and product-specific acceptance criteria must be evaluated by qualified dental professionals.
Quality is built into every stage—measuring, mixing, curing, finishing and inspection. For product-specific instructions, Lang Dental provides a dedicated Product Usage resource and a Safety Data Sheets library.
Educational content • Verify current manufacturer instructions before use
Page 6